1
General Mach Discussion / Re: HOMING ISSUE!!
« on: March 09, 2016, 11:19:39 AM »
Tried to get a good pic but the white box is the soft limits for my machine. So basically my boundaries of where I can cut. While the intersection of the purple lines is suppose to be your machine home. So I have to set up the home limits my working space is only at home because I put it there. So when I load a Gcode in it sets the blue piece on the picture at home. I'm guessing my home is not set right ?idk still trying to figure it out. Anyone have any suggestions or help