Messages

1

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: February 20, 2016, 04:31:57 AM »

so mach3 will not work with 64bit  windows 7, no matter what?

2

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: February 19, 2016, 10:40:51 AM »

Thanks for the reply Tweakie. could this be resolved with a parallel port card? if so, any particular type?

3

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: February 18, 2016, 03:28:40 PM »

hi
I have been working with and around CNC machines my entire working life (over 30 years). I have purchased myself a small CNC router/mill for using at home making, mainly, guitar parts. I have downloaded and installed Mach3 and unfortunately it doesnt work. when running the drivertest it reports "No driver sensed installed. Run driver test" I have repeatedly uninstalled and re-installed to no avail. can anyone advise me as to what i am doing wrong? P C is more than up to spec although, i am wondering, is windows 7 supported?