Hello Guest it is March 28, 2024, 08:31:21 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - skirby

Pages: 1
1
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: February 02, 2016, 10:58:26 AM »
Gerry, Is there a Post Processor for Vectric's Cut3D?  I tried using the Vectric V-Carve Pro Ver 7.5-8.0, but there are several modifications required in order to get Cut3D to load this *.pp file.  I had to comment out the following lines: 30, 32, 66, 85, 89-93, 96, 178, 184 and 186.  The primary function removed by these comments is the DWELL operation, which isn't a operation used in Cut3D.  Do you see anything in my edits that would cause you concern?

Pages: 1