Hello Guest it is March 28, 2024, 11:45:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bobw2961

Pages: 1
1
General Mach Discussion / usb or ethernet controller for Mach 3 & 4?
« on: February 25, 2016, 02:04:19 PM »
I haven't used my cnc router in years.  It has parallel port breakout board and I have a license to Mach 3.  I would like to start using the router again, but all of my computers now are 64bit Window 8 or 10 and no parallel port.
I would like to buy a USB or Ethernet motion control board that will work with Win8/10 and Mach 3 but would like to be able to use Mach 4 sometime in the future.
Is there a motion control board that will work with both Mach 3 and Mach 4 and does it work with Win8 and 10?

Thanks


Pages: 1