1
General Mach Discussion / Re: Retrofit a Laguna Swift DSP to Mach3 control
« on: January 24, 2016, 09:13:37 AM »
Hi,
Thanks for the help!
I hope that I'm not reposting this because I answered once but don't see it here. So,
I have no vacuum table and I would use any of the options, (parallel port, usb, ethernet board, etc...) that is the easiest/best. No preference.
Attached are photos, I hope of a dusty machine control.
doug
Thanks for the help!
I hope that I'm not reposting this because I answered once but don't see it here. So,
I have no vacuum table and I would use any of the options, (parallel port, usb, ethernet board, etc...) that is the easiest/best. No preference.
Attached are photos, I hope of a dusty machine control.
doug