Guest
Show Posts
1
General Mach Discussion / Re: anilam 1100
« on: January 07, 2016, 10:59:25 PM »
help needed !!
my 3 axis anilam 1100m controler lost the memory batt and i think i need to reload the memory with the factory start up floppy,i replaced the batt and the memory is fine now,there were floppys that came w/machine,i loaded them and they didn't seem to be the correct ones,the dro works manualy w/handwheels but no servo activation.
anyone have these ? copy from your machine ?
the floppy i have reads on my pc but has a crc flag as it tries to load to machine.
any info would be helpful.....thanks steve
my 3 axis anilam 1100m controler lost the memory batt and i think i need to reload the memory with the factory start up floppy,i replaced the batt and the memory is fine now,there were floppys that came w/machine,i loaded them and they didn't seem to be the correct ones,the dro works manualy w/handwheels but no servo activation.
anyone have these ? copy from your machine ?
the floppy i have reads on my pc but has a crc flag as it tries to load to machine.
any info would be helpful.....thanks steve