1
HiCON Motion Controller / Re: Issues After Updating Mach4 & HiCON - Can't Move Motors?
« on: February 06, 2018, 10:19:45 AM »
Mauri, thanks.
I spoke with VitalSystems and they were able to get me back up and running. They sent some new firmware and I had some firmware settings that needed to be changed. I missed that my I/O was using J7/8 and needed to update this through the VSI manager. The new firmware they then sent fixed my homing issue as well.
I spoke with VitalSystems and they were able to get me back up and running. They sent some new firmware and I had some firmware settings that needed to be changed. I missed that my I/O was using J7/8 and needed to update this through the VSI manager. The new firmware they then sent fixed my homing issue as well.