Messages

1

General Mach Discussion / Re: Upgrade to Mach 3 / 4 Linuxcnc from PLC, using Panasonic A4 servos.

« on: January 07, 2016, 09:18:28 AM »

Anybody used those line drivers before? The manual for them doesn't spell things out clearly for an idiot like me 



I'm thinking that the GND and +5v I can get from the BOB and that "channel A" could be "DIR pin 2" from the breakout board.

"Channel B" could be "STEP pin 3" from my breakout board? Does that make any sense? 

On the output side that would mean pin 5 and 6 would be the differential DIR signals - & + that get fed into the panasonic drivers?

i use this differential driver, are you still on this forum??

2

General Mach Discussion / Re: Upgrade to Mach 3 / 4 Linuxcnc from PLC, using Panasonic A4 servos.

« on: January 07, 2016, 09:15:02 AM »

Hi, i use the different line driver, are you still on this forum??