Messages

1

Building or Buying a Wood routing table.. Beginnners guide.. / Re: Help with a 2000 Cam Tech Router Master 25

« on: December 06, 2015, 03:43:57 AM »

Any idea on the amount to stop at for a 2000 Cam Tech Router Master 25 that they say does need repair? Any one please help.

2

Building or Buying a Wood routing table.. Beginnners guide.. / Help with a 2000 Cam Tech Router Master 25

« on: December 06, 2015, 12:31:17 AM »

 I am so very new at CNC that is, I have never worked with one as of yet. BUT I am bidding on a 2000 Cam Tech Router Master 25 in an auction as we speak and it will end on Dec 8,2015. It has a Porter Cable 3hp router and states Untested, declared as needing repairs. I contacted the company that was selling the machine. But people in office could not help at all. My question to any one that owns one or has any idea what a good stopping point on bid for a machine like this should be. I saw that people were converting this model with a Mach 3 set up, So if I could not get it to run would this fix any of my problems? I am no stranger to converting things over but is it better to go this route or pay big bucks and buy turn key and go.  Thanks in advance.

3

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: December 03, 2015, 03:22:53 PM »

Hi I go by the name Furry57. I live in BC Canada I googled Cam Tech Router Master 25 and your site came up near top so here I am. What do you think of me so far? I am so very new at CNC that is I have never worked with one as of yet. BUT I am bidding on a 2000 Cam Tech Router Master 25 in an auction as we speak and it will end on Dec 8,2015. It has a Porter Cable 3hp router and states Untested, declared as needing repairs. I contacted the company that was selling the machine. But people in office could not help at all. My question to any one that owns one or has any idea what a good stopping point on bid for a machine like this should be. I saw that people were converting this model with a Mach 3 set up, So if I could not get it to run would this fix any of my problems? I am no stranger to converting things over but is it better to go this route or pay big bucks and buy turn key and go. If this should have been in a different forum please forgive me and please move. Thanks in advance.