1
General Mach Discussion / Re: losing z-axis motor function
« on: December 01, 2015, 01:43:07 PM »
You were absolutely right, it was not a mach3 issue. I went to switch motors and discovered that one of the wires on the encoder plug was faulty. Replaced the pin and it now works.
Tweakie, you mentioned to enable the signal on the z-axis.. not sure how to do that... and would that have alerted me that something wasn't right. Better yet, would it have allowed Mach3 to shut down processing?
thanks
Tweakie, you mentioned to enable the signal on the z-axis.. not sure how to do that... and would that have alerted me that something wasn't right. Better yet, would it have allowed Mach3 to shut down processing?
thanks