1
Galil / Re: Trouble with RESET
« on: November 23, 2015, 10:48:36 PM »
In my attempt to find code that might be on the controller I downloaded a small program to display values of controller parameters. After comparing values when Mach starts and when I issue an RS I noticed the MT values were changing because I had set three of my axes wrong in Galil Configuration - they needed to be set as Servo Reverse.
So now that things seem to be working and I won't have much time to devote to this project until after the new year, should I resume with Mach4?
Thanks for the guidance without your suggestions I would still be fighting the learning curve.
Jeff
So now that things seem to be working and I won't have much time to devote to this project until after the new year, should I resume with Mach4?
Thanks for the guidance without your suggestions I would still be fighting the learning curve.
Jeff