Messages

1

Mach4 General Discussion / Re: Mach 4 Feature Request

« on: November 06, 2015, 05:34:30 PM »

Brilliant, thanks

2

Mach4 General Discussion / Re: Mach 4 Feature Request

« on: November 06, 2015, 05:26:20 PM »

 I believe Mach 3 had the ability to change from CV mode to ES on approaching angles greater than a specified value. Could we have either this feature or some trajectory planning that will allow users like myself with undersized stepper motors / machines that are not as rigid as they should be run our machines a little more effectively. Running my machine in ES is costing me a lot in cutters and time, I would love to get it running more efficiently again.

I think this was already somewhere in the development list, I was mostly hoping for a progress report. Thanks