Hello Guest it is March 28, 2024, 08:58:26 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - djweed

Pages: 1
1
Hi

I'm new to all the cnc hardware and software. so I may need lots of help. I just got a Mach3 hooked up one stepper controller and followed the instructions.  When I opened Mach 3 software and followed those instructions it shows that the card is there but the reset button won't reset. I don't know what to look for next.

Dave


Pages: 1