Hello Guest it is March 29, 2024, 10:54:29 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - finyl vinyl

Pages: 1
1
General Mach Discussion / Please help, Chinese eBay purchase!!
« on: October 23, 2015, 02:43:31 PM »
Hi
Yes I bought a 3 axis 3040T-DQ CNC router from eBay,!

The instructions are next to useless and certainly not in anything resembling English.
I have assembled it, I think and loaded Mach 3 from the Internet as the disc supplied would not open. My issue is trying to set up home stops, I also a component "left over" it is a round disc like object with a single Jack  plug and crock clip, I can find no reference anywhere in the instructions as to what it is, I assume it could be a home stop or similar.
Any help would be brilliant particularly if there is a user in the UK that I could phone for advice, email address is: Rush.den@hotmail.co.uk

Thanks in advance

Paul

2
General Mach Discussion / Re: Newbie issues
« on: October 21, 2015, 05:11:55 PM »
Thanks Gerry, I have checked port address? I have 32 bit machine and can check a new cable tomorrow morning
I also gave an issue in the diagnostic screen in that the LEDs flash with the table turned on or off, is this possiblely related also?

Sorry to be needy but I am very frustrated

Regards
Paul

3
General Mach Discussion / Newbie issues
« on: October 21, 2015, 03:24:11 PM »
hi, I am very new to Mach3 and CNC router, I have purchased a table top system and have down loaded mach3 I have gone through set up (twice actually as I uninstalled and started again) however I have a problem:
The DRO works perfectly whilst jogging however the table etc does not respond

I have watched the 3 videos on u tube and ensured that all appears correct, any ideas, my only thought is that the series cable is faulty?

Any ideas gratefully recieved
Paul

4
Hi, I am in the UK and very new to the world of CNC routing and MACH3, a nurse by background who is now looking to start a new venture, carving / cutting Vinyl Records to create  clocks. I purchased a 3040 from Ebay2 weks ago
I am haveing issues tryng to generate g codes ?? from designs and pictures.

I look forward to tips andsupport that can be offered

Pages: 1