Hello Guest it is March 28, 2024, 05:22:47 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dwrightny2266

Pages: 1 2 »
1
General Mach Discussion / Re: Strange Axis movement
« on: December 31, 2015, 11:01:01 AM »
Like anything else, the more we know, the more we find that we don't know :)

Thanks again.

2
General Mach Discussion / Re: Strange Axis movement
« on: December 31, 2015, 10:47:30 AM »
Spending some time watching some videos and researching this more.

Thank you for your help :)

3
General Mach Discussion / Re: Strange Axis movement
« on: December 31, 2015, 10:36:07 AM »
 Should I normally be in Abs or inc mode or is that not a simple question to answer?

4
General Mach Discussion / Re: Strange Axis movement
« on: December 31, 2015, 10:21:29 AM »
It will move out in one direction 5" but return in a different measurement.
In the General Logic Config Panel, the distance mode is Absolute, and IJ in Inc.

Need to learn more about it. Still in learning mode lol

5
General Mach Discussion / Strange Axis movement
« on: December 31, 2015, 09:55:47 AM »
Setting up a new controller, and i noticed that all axis don't return to the same position that the left from.  For example 
Starting at 0
G0
X 5"
X-5" (expecting to be at 0)
But ending at -2" on both x and y axis.

Any ideas?

6
General Mach Discussion / Re: 2 Machines 1 Computer
« on: November 03, 2015, 08:24:50 PM »
Yes it does. thank you very much :)

7
General Mach Discussion / 2 Machines 1 Computer
« on: November 03, 2015, 07:23:52 PM »
I have one small CNC running, and a second setup to play with G-code for robotics.  I have 2 LPT ports but not sure how to run both setups (1 at a time), without changing the Port Pins back and forth for each setup.  Both are using different boards, so the pins are different.

8
General Mach Discussion / Re: Random Direction
« on: October 18, 2015, 02:33:28 PM »
Thanks a bunch!!  I have a buddy who may have one and looking to see if it will fit.  If not, there only $10-$15 on ebay, and can have it by Tuesday.  Then its off to the races lol :) Thanks again!!

9
General Mach Discussion / Re: Random Direction
« on: October 18, 2015, 10:09:29 AM »
And yes it's a parallel port connection. 

10
General Mach Discussion / Re: Random Direction
« on: October 18, 2015, 09:58:05 AM »
Worth a shot to look into it.  Sent the seller/OEM a message to see what their thoughts are.  Much appreciate the feed back.

Pages: 1 2 »