1
General Mach Discussion / Help with setting up 4 Axis for cutting Foam Wings X X1 Z Z1
« on: September 27, 2015, 11:05:40 PM »
I have completed most of my CNC build for cutting foam wings with a hot wire cutter. It would be great if I could get some help on the CNC G-Code software to run my cutter. Can Mac3 work for me? Also if so how do I set it up for 4 Axis to cut tapered wings. Currently I am using the demo version of Mac 3 to test my motors, CNC board, Motors, Motor Driver Boards. I require X , X1, Y, Y1
This is the link to my build on open builds org. It shows what my machine will look like.
http://www.openbuilds.com/builds/cnc-hot-wire-cutter-4-axis-for-cutting-foam-wings.2508/
I have yet to purchase the C-Beam Actuators that the motors will drive to run the wire.
This is the link to my build on open builds org. It shows what my machine will look like.
http://www.openbuilds.com/builds/cnc-hot-wire-cutter-4-axis-for-cutting-foam-wings.2508/
I have yet to purchase the C-Beam Actuators that the motors will drive to run the wire.