Hello Guest it is March 28, 2024, 08:57:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Destroyer

Pages: 1
1
General Mach Discussion / I need help!
« on: September 20, 2015, 09:57:51 PM »
Hi guys,

I'm wondering if anyone can help me?

I bought a 6040 Cnc machine off  EBay and have loaded Mach3 into my computer, I'm having trouble with the set  up and I've looked everywhere for help.
My issue is that stepper moater keys used on the computer work fine but not on the table. I can't figure it out.
Would anyone kindly screenshot all of their settings for me or point me in the right direction??

Any help would be greatly appreciated.

2
General Mach Discussion / Re: ABC's of YOOCNC 6040Z Setup
« on: September 20, 2015, 09:41:44 PM »
Hi,

I have a question for you and I wonder if you can help me?

I have a 6040 CNC machine I have loaded Mach3 onto my computer and I have used these settings above. The issue in having is the stepper moater keys used on the program work on the computer but not on the table.

Could you please if possible send me screenshots of all the settings that you are using??

Thank you! =]

Pages: 1