Hello Guest it is March 29, 2024, 06:15:30 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - manos3

Pages: 1
1
JetCam screen designer / Re: List of Jetcam requests :)
« on: September 15, 2015, 03:29:42 AM »
Hello,

   the company i work for have a punching machine and we use Jetcam in order to do the tooling. We had a round 10mm tool on amultitool and recently we bought a 10mm tool for a single station. Is there a way that i can decide when to use each tool?

   So far whenever i have a 10mm punch Jetcam "decides" to use the multitool...

   Best regards,
      manos

Pages: 1