Hello Guest it is March 28, 2024, 04:45:21 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - webdirector

Pages: 1
1
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: September 19, 2015, 02:54:50 PM »
Thanks,

My wife always tell me: ...... Read................ continue reading................read till the end ........... then you will know more then most  ;D

Thanks

2
General Mach Discussion / Re: Set JOG Mode to Cont.
« on: September 19, 2015, 01:48:47 PM »
......... I have screenset 2010

so I did not have MDI

sorry

3
General Mach Discussion / Re: Set JOG Mode to Cont.
« on: September 19, 2015, 01:46:32 PM »
Hello,

Thanks for quick answer.


as said I am still new to mach3 ..........

What is MDI screen ?

sorry for being a Noob

4
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: September 19, 2015, 01:44:44 PM »
Hello Gerry,

I bought the screen set and I put the resolution of my monitor to 1024x768 I also put the
window task bar to auto hide.

My problem is that when i turn on the "Diagnostic" screen it seeems to cut of the right side of that windo ( I mean I do not see the red "X" at the top to close the windos

Any Idea why this is so ?

Thanks

5
General Mach Discussion / Set JOG Mode to Cont.
« on: September 19, 2015, 01:29:25 PM »
Hello,

I installed Mach 3 and it has been working great. Just some small things ........

1- When I startMach3 Mill the JOG mode is always in "Step" mode. Is ther a way to set is so JOG mode would always be when started in "Cont." mode ?

2- In JOG Mode when I am in "Step" mode it moves only very slow Is there a place to adjust the speed ?

I know these are probably simple questions but I doi not seem to be able to find this

Thanks for support


6
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: September 13, 2015, 10:41:26 AM »
Hello,

I have a question before i buy.

One of the key things I would like to have is the "Auto Tool zero"

I see you need two plates ( one movable plate  and a second fixed plate )

My problem is I only have 1 input on my board available. ( since I am using a smooth ethernet stepper, I am hesitant to connect a second board, I could not find anything on internet where people have done this)

so my question is can I connect these two plates in parralel ?

Thanks

Pages: 1