Hello Guest it is September 21, 2023, 09:41:52 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - atsersion

Pages: 1
1
Hi All,

  Just wanted to provide feedback that I got my issue figured out, thank you Tim, it was in the setup.  Appreciate the assistance.

2
Hello All,

  I just finished building my CNC Router, with the design from Dave Gatton.  I got all the motors running and have been trying to figure out Mach 3, while setting up the soft limits, my table measures 33" (x),  23" (y) and 6" (z), but when I read the DRO's of travel for all three axis the read outs show double.  So the X is 66", Y is 46" and Z is 12".  Any thoughts?  I have plenty more questions but I'll submit another post for that, don't want to get too confused.  Thanks All.

Arron

Pages: 1