Hello Guest it is September 21, 2019, 07:51:57 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Markyjones

Pages: 1
1
General Mach Discussion / Re: Programme dwelling
« on: September 12, 2015, 03:36:09 AM »
Sorry I have been offline for a while, cannot find anything wrong with the programme. Have linked up to another PC and the machine runs through the programme without a problem. I am still a little puzzled as to why I have the problem with the other PC, Is it the PC?
Thanks for your thoughts on the problem much appreciated.

2
General Mach Discussion / Re: Programme dwelling
« on: August 29, 2015, 05:44:53 AM »
ThanksTP this is what I thought I have been through all the settings on both pc's and the check box for dwell has not been checked on either. so I am confused as to why the cutting programme is dwelling.

3
General Mach Discussion / Re: Programme dwelling
« on: August 28, 2015, 07:43:07 PM »
I already have one machine controlled by the Mach3 software which runs without any problem, this is run throuh a HP desktop PC.
I used the same compressed file to load programme into a Dell desktop PC, Mach3 programme loaded fine.

I duplicated all the settings from the one that is running fine, double and triple checked.

I created a programme using artcam software, created the G-code file. Loaded that file into Mach3. Clicked on the start button and the machine responds to the commands, until it gets to line 997 of the G-code file then the Dwell light flashes on the Mach 3 screen.

No message comes up it the message box at the bottom of screen.

Swapped over to the HP pc and the same G-code runs fine.

Hope there is enough detail for you, and many many thanks for your reply.
Jona

4
General Mach Discussion / Programme dwelling
« on: August 27, 2015, 04:20:21 PM »
I am having a problem with the Mach 3 programme, I start the programme and it runs for about 2 minutes and then the programme dwells. I am not able to continue any further into the cutting programme. Has anyone got any ideas on why this is happening, it's driving me mad.

Pages: 1