Messages

1

PoKeys / Re: Mach3 and Pokeys Error Code 200702 and 9991

« on: August 31, 2015, 02:38:56 PM »

nobody can help me ?

2

PoKeys / Re: Mach3 and Pokeys Error Code 200702 and 9991

« on: August 28, 2015, 09:23:17 AM »

I have now but another problem .
When I installed the plugin and now in Mach3 on " Plugin Control " then go to "Configure Pokeys 56U *********xx " and then in "Pulse engine settings" tab " Integrated 3ch " configuriere and then reboot Mach3 , then the plugin inactive and get then no longer activated. That means I have to delete the plug-in and reinstall . In addition comes after the launch of Mach3 not the " window Motion Control hardware plugin sensed " so I can select Pokeys ... What am I doing wrong


greeting
Timo

3

PoKeys / Re: Mach3 and Pokeys Error Code 200702 and 9991

« on: August 27, 2015, 01:05:49 PM »

Thanks , now it works!

4

PoKeys / Re: Mach3 and Pokeys Error Code 200702 and 9991

« on: August 24, 2015, 02:36:27 PM »

Which version of Mach3 and PoKeys software are you using?

Mach 3 Version R3.043.022
Pokeys Version V3.1.56

5

PoKeys / Mach3 and Pokeys Error Code 200702 and 9991

« on: August 24, 2015, 12:18:05 PM »

Dear Mach3 community
I have the following problem with the Mach 3 software .
I recently purchased the Pokeys56U . Now I wanted to configure it with my Mach3 and have for the plugin " Pokeys.dll " installed .
Now when I open Mach3 and the plugin under " Plugin Control " Configuriere , place of the Pokeys also . After Configuration says with Mach3 I need to restart the program . After the restart then comes but once an error message " Error triggred with the error number 200702 and 9991 "
Thereafter, the program crashes and I have to restart it. Then again the same error . Now I can start the program Mach3 only when I remove the USB cable from Pokeys .

Has any one of you a solution to the problem ?

Sorry for my english , I 'm from Germany


greeting
Timo