1
Third party software and hardware support forums. / Re: Syil X2 cnc controller question
« on: June 18, 2007, 05:19:27 PM »
Thanks man for the info.
Unfortunately just measured 48V DC on the power supply output wires that goes in the breakout board.
I assume that the voltage regulator LM7805 must have failed, it gets really hot and it does not have any heat sink
Do not know how to test it though...
Unfortunately just measured 48V DC on the power supply output wires that goes in the breakout board.
I assume that the voltage regulator LM7805 must have failed, it gets really hot and it does not have any heat sink
Do not know how to test it though...