1
General Mach Discussion / Re: Mach3 Calibration with GearBox
« on: August 13, 2015, 02:18:19 AM »
İ need Formule dear.. i have many documents about that but when i test .. step per is wrong so i wrote my specifaction.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
You've not provided enough information, as we need to know either your Z screw pitch, or Z axis tooth spacing/pitch (you say pinion, so I'm going to assume you're using a rack?)
If you want to understand how to calculate the steps, have a read of this article - http://www.uk-cnc.com/2015/07/25/calculating-steps/