Hello Guest it is March 29, 2024, 05:21:04 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - andykirk50

Pages: 1
1
G-Code, CAD, and CAM discussions / Re: FUSION 360 - LATHE
« on: March 09, 2017, 07:03:04 AM »
hello alll

i have also been playing with fusion 360 and trying different posts to see which one works
ive tried the Mach3 and the fanuc posts but both are giving me a strange error

ive attached the code im using but at the end of each step in the work piece there should be a 1mm radiius, instead it is trying to dig into the work.




2
General Mach Discussion / spindle reset button and + -
« on: June 04, 2016, 04:01:52 PM »
hello all.

finally got round to setting up my cpo-10v BOB from cnc4you today and linking to my 2.2kw VFD and spindle.

on the mach3 side of it I thought all was looking good. the spindle starts and stops and I can set a speed and it runs and gives the correct speed however, when I press the spindle reset button or try to increase or decrease the speed with the + or - arrows it automatically jumps to full speed.
I have checked the volts output and as soon as I press the reset spindle speed or + or - the volts jump straight to 10v, so this has to be a mach 3 problem and not my vfd.

anyone have any thoughts on the above

kind regards

3
Promote and discuss your product / Re: Mach3 as 3d printer software
« on: September 28, 2015, 06:33:46 PM »
Hello all.
Has anyone gotten around to making a video on the installation and set up of Nuri control board and the setting used for Mach 3?

4
VB and the development of wizards / Digitising 2.5d probing.
« on: August 04, 2015, 03:14:57 PM »
Hello

Just wondering if there was any new updates on 2.5d or 3d digital probing, or if anyone one know of some Google free software.
I'm probably like most people on here as a hobbyist that can't afford expensive software so anything cheap or free please

Thanks 

Pages: 1