1
General Mach Discussion / Re: servo motors overheating and losing steps when jogging
« on: August 14, 2015, 09:20:39 PM »
Also, am I supposed to connect the neutral coming off the motors to the chasis of my machine?
I connected the neutral coming off of the 110, to the chasis on my control box. Is that correct?
Then I put that neutral on an empty block, should I ground that neutral to my machine aswell?
I connected the neutral coming off of the 110, to the chasis on my control box. Is that correct?
Then I put that neutral on an empty block, should I ground that neutral to my machine aswell?