Messages

1

General Mach Discussion / Re: Pink bulls-eye overlay

« on: July 25, 2015, 07:02:13 PM »

Thankyou, this works

2

General Mach Discussion / Pink bulls-eye overlay

« on: July 25, 2015, 03:06:51 PM »

Hi, I've just been testing and using my new license for Mach3 with this piece of g-code I created using cambam. The only issue I have is this pink (bulls-eye) like overlay which seems to be included within the final product.. How can I get rid of this? (I only want the house underneath)

I went onto the cambam forum already and they claimed it was probably mach3 related, thanks

Iceknight

picture:

http://imgur.com/gallery/LXPx0wQ/new

3

General Mach Discussion / Mach 3 trial to full version

« on: July 24, 2015, 07:16:59 PM »

Hi, I'm a newbie to mach3 and was wondering if I can keep the information from my trial version (I.e. Configuration) and transfer it to a full version of mach3 which I am about to purchase.. Also, the computer which houses mach3 is not connected to the internet, so would it be possible to purchase Mach3 from another computer and use it on the non connected appropriate computer? Thanks

4

General Mach Discussion / Re: CamBam to Mach3

« on: July 22, 2015, 08:05:56 AM »

That sounds useful, I'll sign up, thanks

5

General Mach Discussion / Re: CamBam to Mach3

« on: July 21, 2015, 03:11:20 PM »

Ok, that's most definitely the issue then. Thankyou very much

6

General Mach Discussion / Re: CamBam to Mach3

« on: July 21, 2015, 02:46:19 PM »

I am currently using the trial version of Mach3; would I be required to purchse the full version? The GCODE I uploaded was very detailed; so this most likely could be the issue if my GCODE exceeded any limitations on the trial version of Mach3

7

General Mach Discussion / CamBam to Mach3

« on: July 21, 2015, 02:01:12 PM »

Hi, I'm new to Mach3 and this community.. Recently I imported a CAD dxf file to CamBam, altered it's size appropriately, and generated tool paths; after I was satisfied, I generated the GCODE and loaded it onto a memory stick and then to my CNC router's computer.. After opening the file on Mach3, the toolpath became distorted/not all of the toolpath was showing and no error messages were displayed. I ran the software and the result was wrong; how can I ensure that the toolpaths and GCODE are loaded properly when using CamBam to transfer GCODE? (using .nc files) Thanks