Hello Guest it is December 03, 2021, 03:21:20 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jkan101

Pages: 1
1
General Mach Discussion / axis a set up in mach 3
« on: January 13, 2017, 06:40:32 PM »
Just got my 4th axis for my taig mill.....when into ports and pins and enabled axis a and also checked off dirlowactive.....went into the motor tuning and setup and entered all the info there........and I get nothing when I try to jog the a axis .......any ideas or did I miss something?


Thanks

Joe

2
General Mach Discussion / Re: gcode issue
« on: July 31, 2015, 04:41:07 PM »
You were right Thanks lol sorry pretty nooobish of me...Reinstalled all is well.

Joe

3
General Mach Discussion / Re: gcode issue
« on: July 31, 2015, 04:31:22 PM »
Thanks...I have a license I guess I did not install it correctly?

Joe

4
General Mach Discussion / gcode issue
« on: July 31, 2015, 03:30:40 PM »
Whomever,
I have a problem when I run this gcode program it will only go to line 483 and stop there instead of going to the end. Even if I try to look at it in the window its open again it only goes to line 483 and stops but if I hit the edit gcode button I can see the g code all the way to the end of the line which is 761. Not sure if this is a Mach 3 issue or bobcad issue. Thanks

Joe

5
General Mach Discussion / Re: simulate
« on: July 13, 2015, 01:08:45 PM »
Thank you Overloaded--I ended up just reloading Mach 3 and all is well it works,and I took your advice and created a profile again Thanks

Joe

6
General Mach Discussion / Re: simulate
« on: July 13, 2015, 11:04:04 AM »
I appreciate the answer however I am a newb and I dont know which driver your talking about...I got on it this morning and now when I hit jog the dro's dont move now, also on the tab at the bottom left screen it says Mach3 cnc demo. Should I reload the mach 3 program?

Thanks

Joe

7
General Mach Discussion / simulate
« on: July 12, 2015, 11:56:20 PM »
Having abit of an issue with my mill...I  am new however I did setup my my mill,motors, controller and everything was working great. I turned everything on today and I noticed when I jogged that the dro was moving and not the motors.

I checked the control box and checked the reset button all was well....I went to the diagnostics page and noticed that under ---pulse frequency it said simulate..I never saw that before...usually there are numbers here...also in the Time in Int. it says +0.0. I must have put it into simulation somehow I dont know how----If someone would help me out I would appreciate it greatly.


Thanks


Joe

Pages: 1