Messages

1

General Mach Discussion / Re: X axis reversed

« on: July 12, 2015, 07:45:30 AM »

Hi Tweakie that is what I have done
Before I reversed it in the homing page I did a test run on a small disc without cutter using bottom left as the start it went to the left instead of the right but after reversing it was ok.
Cheers
Bill

2

General Mach Discussion / X axis reversed

« on: July 12, 2015, 05:25:12 AM »

Hi firstly I am totally new to cnc
I have setup mach3 in demo mode and all the axis move in the correct directions via the comp keyboard but when I press tab and call out the jog controls the x-axis moves the wrong direction
If I reverse the direction in the limits page all that does is now the axis moves correct on the jog controls but reversed on the keyboard
The same thing happens if I change the direction in the ports and pins page.
So has anyone got any suggestions as how to cure this.
Many thanks
Bill