Hello Guest it is March 28, 2024, 07:22:23 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Royke

Pages: 1
1
General Mach Discussion / Re: Scrolling Error in Mach 3
« on: June 27, 2015, 06:29:29 PM »
JohnHaine,

I appreciate the response.  I was thinking that as well.  I did take a quick look where I would initially expect a wire to be loose and all looked good.  I will take a harder look.

Cheers,
Royke

2
General Mach Discussion / Scrolling Error in Mach 3
« on: June 27, 2015, 03:32:08 AM »
I cannot move my router in the negative (left) direction in the X-axis.  Both my right and left arrows moves it in the positive (right) direction.  The same thing is happening when I am using my X-box controller.  I have not been on it for about two weeks.  I have never had this problem before (I have only had it up and running for 18 months).

I have no skills in the diagnostics of Mach 3.  I am an amateur in the CNC machining world.  My Mach 3 was setup by the individual I bought my DIY kit through.

Any help would be appreciated!

V/r,
Royke

Pages: 1