Hello Guest it is March 28, 2024, 06:50:05 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Lc1975

Pages: 1
1
Finished Screens / Re: Mach3 DarkScreen Screenset - Now Available
« on: October 14, 2019, 07:48:50 AM »
Very nice screenset.
Great work!
:)

2
Hello...
Philip from PT
Just a real newbie...
Triyng to learn to see if i can get better results in life....

:)

3
Mach Screens / screenset 2010 problem...
« on: October 08, 2019, 09:01:35 AM »
Hello..
Newbie here..
:)

I have a STB5100 chinese usb motion with driver: bl-UsbMach v3.2
It appears to be nice board but the driver....
Welll is chinese...
I'm using 2010 sreenset but i'm having lot a problems to Auto Tool Zero..

I went to the site and download the files with the changes for the chinese drivers..
Ok
And now the problem..

Manually using the macro to see the tool zero..

Until this line:
Quote
Call SetOEMDRO (802, TotalOffset) ' Set the Z axis DRO to plate thickness
sleep(500) ' Pause for DRO to update.
I think that is all ok..

But when i goes to this line:
Quote
Code "G0 Z" & ZClear ' Retract to Z Clearance Plane

While IsMoving()
Wend
The Z coordinate goes to "0" and the tool goes down 5mm and not retracting...

Appears on the Z coordinate: +5mm

And not the 16.5mm that should retract...?    ( The 11.5 from the plate + 5mm clearence )

Is there any solution...
Or this board is just to remeber a bad buy......

Any help i appreciate..

Regards.

Pages: 1