Messages

1

Modbus / Re: HELP! complete access to modbus by VBscript

« on: June 12, 2015, 06:01:19 AM »

May be I wrong section, because I'm asking help for Mach3. Could I post again in right section? If yes, which is? sorry!

2

Modbus / HELP! complete access to modbus by VBscript

« on: June 12, 2015, 05:58:29 AM »

Hi, I need your help!!!

I have to read and write, in a precise sequence, some data into plugin Modbus addresses. My VFD must receive different values to kick off the boot sequence of the electrospindle. These values are to be chosen according that reading on others address. I think should then use a VBscript macro to insert an IF loop control  but the problem is that I cant find anywhere a complete documentation of reading and writing routines on the Modbus.

I also tried the way of the Brain but ... worse still!! 

VFD is connected via RS232 to RS485 adapter, the fully functional and tested by Mach3's Modbus serial control monitor.

3

Modbus / Re: Different kind of input

« on: June 11, 2015, 10:34:36 AM »

Thanks a lot SSPW! That's exactly I'm looking for.

4

Modbus / Different kind of input

« on: June 09, 2015, 01:54:37 AM »

Hi everyone and, first of all, sorry for my english!

Could someone let me understand the difference between kind of input, such as input-coils, input-holding, input-reg and input-discrete?

Also indicate another topic where I can find it,  tried to check using find box but without right results.

Thanks a lot