Hello Guest it is March 28, 2024, 08:20:06 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Shawn Bierworth

Pages: 1
1
General Mach Discussion / Re: Help with older Techno Isel
« on: March 16, 2006, 05:47:53 AM »
If that is the easiest, thats the way I would like to go. I should be able to keep the machine itself intact motor wise and just plug into  a new controller, correct? I would like to purchase a plug and play controller. Any suggestions on what and where to purcase one?
Thanks so much
Shawn

2
General Mach Discussion / Help with older Techno Isel
« on: March 15, 2006, 05:39:38 PM »
I just acquired a Techno Isel gantry with steppers (HX33SBM201201505).It has the MAC200SD controller with the SD15 cards. I wish to use the MACH2CNC program, in order to update to standard G code. What do I need to do this? Do I need to dump the MAC200SD controller and if so,what does the forum recommend as a substitute? If I can use the MAC200SD, can someone fill me in on the settings to use. I have Mastercam version 6 for a cam package. Thanks for any help.

Pages: 1