Hello Guest it is March 29, 2024, 09:23:52 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jcraft

Pages: 1
1
General Mach Discussion / Re: Mach3 Freezig on XP SP3
« on: May 03, 2015, 11:55:17 AM »
Found them, sitting at 2.5V which apparently is normal.


2
General Mach Discussion / Re: Mach3 Freezig on XP SP3
« on: May 03, 2015, 11:48:14 AM »
Hi Hood
I've just been through all the BIOS and it's not showing me the voltages, I've had he machine form new and it's not been overclocked so would suspect ther're fine. will see if I can find some software to confirm them though.
James

3
General Mach Discussion / Re: Mach3 Freezig on XP SP3
« on: May 03, 2015, 11:10:31 AM »
CPU is 0-2% when Idle 27-30% running a cut.
james

4
General Mach Discussion / Re: Mach3 Freezig on XP SP3
« on: May 03, 2015, 10:37:24 AM »
Core temps are all good sitting at 28deg C

5
General Mach Discussion / Re: Mach3 Freezig on XP SP3
« on: May 03, 2015, 10:30:45 AM »
Hi, The board looks ok, I cleaned it all out yesterday and had a good look at it. I didn't think to check the temps though so I'll have a look at that.
Yes I'm running on the parallel port, kernal speed is set to 35,000 and the time int is running between 4.1 and 5.8
the driver test runs fine and shows the system as excellent, with 34800PPS
Thanks for helping

James

6
General Mach Discussion / Mach3 Freezig on XP SP3
« on: May 03, 2015, 09:07:14 AM »
Hello all, I've been runing Mach3 for about a month now and it's been sporadically freezing up my system.
Running a stand alone desktop, all screensavers etc are off, no wifi or internet.
It will run all day without a problem, but with Mach3 running it will freeze, not every time but it's becomming more common, last night it froze whilst running a job.
the system becomes completely frozen, switching the controller off makes no difference and I cant even Ctrl Alt Del to get it to come back.
it tends to happen when first loading my mill, but will happen at any point.

Dell Dimension 2400
Pentium 4 2.4Ghz
512MB Ram


any ideas?

Thanks in advance

Pages: 1