1
General Mach Discussion / Re: Help with Plasma G31 Probe On Floating head
« on: April 30, 2015, 03:24:21 PM »
Looked under the help/ and my name was there so its not in demo.
Used the G31 Z-2 F5 code and the Z just zeroed and never drives down to touch off.
The probe led didn't light up to tell it that it touched off.
If I trigger the switch the probe led lights up.
Used the G31 Z-2 F5 code and the Z just zeroed and never drives down to touch off.
The probe led didn't light up to tell it that it touched off.
If I trigger the switch the probe led lights up.