1
General Mach Discussion / Re: Hallo, just another one with a spindel problem
« on: May 24, 2015, 07:03:15 AM »
Heej Rich,
Thanks for responding.
Unfortunately i am not so handy using the forum.
for a lot of the people here is normal to know how it works, but for me, yesterday i found out were the button off the PC was and this moring it managed to ask a question in the forum but how i did that?? , that's not al my englisch is not so good so please have a little patience with me.
First question: Members doc's? were can i find them?
How can i send a picture in a reply, i tried but?
the Mach3 version i am using is R3.043.066 (is this right?)
XML File? looked in the mach3 folder but couldnot find it.
Breakout board is from China, i recently bought it, changed it for my old board what was working with a parrallepoort and now its working with USB (aliexpres Xhc bord from martathome).
My VFD is a AF500 from Sumitomo, is a older one. i can send a picture of de conecting diagram (if posible and when i know how). with the output signal from the board i can settle the RPM speed now.
Oke..
Hope that you can help me further to get it working...
Greets,Wilco
Thanks for responding.
Unfortunately i am not so handy using the forum.
for a lot of the people here is normal to know how it works, but for me, yesterday i found out were the button off the PC was and this moring it managed to ask a question in the forum but how i did that?? , that's not al my englisch is not so good so please have a little patience with me.
First question: Members doc's? were can i find them?
How can i send a picture in a reply, i tried but?
the Mach3 version i am using is R3.043.066 (is this right?)
XML File? looked in the mach3 folder but couldnot find it.
Breakout board is from China, i recently bought it, changed it for my old board what was working with a parrallepoort and now its working with USB (aliexpres Xhc bord from martathome).
My VFD is a AF500 from Sumitomo, is a older one. i can send a picture of de conecting diagram (if posible and when i know how). with the output signal from the board i can settle the RPM speed now.
Oke..
Hope that you can help me further to get it working...
Greets,Wilco