1
General Mach Discussion / techno isel refit
« on: June 13, 2007, 03:07:19 PM »
Hi I have a techno servo router with a dos based controle.
The machine it self an the elctronics work fine.
The controler also works but its a pain.
Does anybody hear have any experience converting one of these to run with mach3 or an older version.
I was hoping to be able to somehow interface with the aktual box rather then having to build a new one with gecko drives ore something like that.
at the moment I just want to no if anybody here has already done so or at least thought about it.
Thanks
KAI
The machine it self an the elctronics work fine.
The controler also works but its a pain.
Does anybody hear have any experience converting one of these to run with mach3 or an older version.
I was hoping to be able to somehow interface with the aktual box rather then having to build a new one with gecko drives ore something like that.
at the moment I just want to no if anybody here has already done so or at least thought about it.
Thanks
KAI