Hello Guest it is March 29, 2024, 08:10:53 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Kru82

Pages: 1
1
Hey all . Thanks for the extended education I have been getting reading the in's and out's of it all . So far no problems with Mach 3 in an older Dell with XP , keeping it a totally dedicated machine . ( no internet , music , videos or solitaire while the program does what it was intended to do )  Deleted a lot of the unnecessary programs and files not associated . Have a second comp for the graphics and such . Fingers crossed it doesn't have a melt down . I'll do my best to be able to contribute , yet the rookie is still learning .

My use of the program is going with this machine , so here is the link    http://www.cnczone.com/forums/uncategorised-woodworking-machines/263942-arrived-gerber-dimension-200-e-times-2-a.html


Thanks again .

Kru82 ( JP )

Pages: 1