Hello Guest it is May 06, 2021, 03:30:21 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Cressida46

Pages: 1
General Mach Discussion / How to reset RESET?
« on: March 29, 2015, 09:56:33 PM »
e-Stop RESET locks out on MachIII launch. 

No servo or control access. Workscreen and settings appear fine.

How to fix?  Or find the Troubleshooters Guide at the end of the Universe?



It's Al here at a high school in eastern Ontario Canada.  A newbie to CNC with a recently refurb'd 36" gantry router, two Sherline mills and a lathe running
Mach III.  As a sideline, I manufacturer a line of consumer electronic products using onshore talent and offshore production.  Gadgets for family fun.

I am hoping to get a grasp of the basics of MachIII, LazyCAM and some student-friendly modelling program (tbd) so my students will be able to do a few  simple projects that they can be proud of.   However . . .

As an analog guy from the old days, I fear the vagaries of software control and operating systems (and their endless updates) might make this impossible.

With help from the friendly folks here I am hoping the learning curve will flatten quickly and chips will fly soon.

All good things,


Pages: 1