Messages

1

General Mach Discussion / Re: MaxNC 10 SRV

« on: March 01, 2015, 05:49:46 PM »

yeah, that i was afrade of that, i will try to get the software from MaxNC directly, but i doubt they will still support a machine that is this old. if all else fails i can rewire it

2

General Mach Discussion / Re: MaxNC 10 SRV

« on: March 01, 2015, 04:58:50 PM »

after setting all the motor outputs to 0 it seems to jog around but all the outputs seems to be wrong.

the up arrow turns on the motor
Left and right moves the machine in and out
and clicking on Z moves the machine left and right? Not sure how this is possible the Z and A axis should have been on a separate parallel port that isn't hooked up.

3

General Mach Discussion / Re: MaxNC 10 SRV

« on: March 01, 2015, 03:02:52 PM »

selecting wave drive mode doesn't seem to enable the outputs. do i need to do anything in the output panel ?

4

General Mach Discussion / MaxNC 10 SRV

« on: March 01, 2015, 12:04:14 AM »

Hi, i have an old Max Nc 10  SRV unit laying around that i would like to get working. I have looked everywhere and can' t seem to find information about running this type of machine with Mach 3. Is it possible to drive this machine with Mach 3 without rewiring it ?