Hello Guest it is March 28, 2024, 10:58:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - BenV

Pages: 1
1
General Mach Discussion / Re: Setting Machine Coord's and Offsets
« on: October 22, 2015, 08:27:17 PM »
Anyone have any idea way V.I.D and product id have to be reinstalled over and over ??? For an xbox controller using Lee Davis Plug in.

2
General Mach Discussion / Setting Machine Coord's and Offsets
« on: March 04, 2015, 08:07:59 AM »
Can anybody provide information on setting machine coord's.  I guess it needs to be set on the offset tab, but can't figure it out.  Even if somebody can point me to a book or learning outlet it would be helpful.

Pages: 1