Hello Guest it is March 29, 2024, 02:03:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - AUB

Pages: 1
1
General Mach Discussion / Re: New Install and motors will not react.
« on: February 24, 2015, 09:19:21 AM »
Yes i have it set to 0378. MP3000 is getting a signal due to the cp light coming on the front of the MP3000 unit.


2
General Mach Discussion / New Install and motors will not react.
« on: February 23, 2015, 08:14:53 PM »
I recently had to change computers and install a newer version of Mach3. I have an existing plasma table that was working with the older version. I also upgraded from a CandCNC MP1000 to a MP3000. The screens look good, each axis on the screen shows that they are incrementing or decrementing due to jog commands or G code. I do not however get any motion out of the motors. The motors are under power and are "holding". I've been through both the Mach manual and the CandCNC manual and cannot find an issue.  Any starting points for identifying my problem(s)?

Pages: 1