Hello Guest it is June 20, 2019, 07:52:12 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - DeaZ

Pages: 1 2 »
1
Hi!
Thanks for trying but I believe it's something else due to the fact that is has been working fine before I went to try use it.
Going to give up now and let a professional look at it.
Thanks for your time.
DeaZ

2
When I use the UC100 plugin and jogs manually I can see the pin state for 3,5 and 7 turn red and white. Also the jog and run is turning red when I jog and when I am not the idle led is red.
The time indicator is moving rapidly all the time without me or the mach3 doing anything.

3
The LED lights on the UC100 indicates that is it working and is connected to my computer without firmware problem. I believe that something else is wrong.

4
Okey I'm going to read some manuals. I tried finding the drivertest in my mach3 folder but couldn't find there or on the web. Do you have a link?

5
Isn't there some way I can just test if it can move? I mean when I start the cycle everything looks good on mach3 and it follow the toolpath  but my machine isn't doing anything more than clicks after I change settings. I feel so hopeless... :(
Thanks anyway

6
When I check the ports for the UC100 I get: Port_#0003.Hub_#0004 so should my port adress be 0003?

7
I think that it has nothing to do with the UC100 it's just making me able to use the usb. This is the box: http://www.jbcnc.se/product_info.php?products_id=474&language=en

8
Hi

It's so hard explaining something I have no clue about xD I have mach3 on my laptop and it is connected thru usb to some 5A 230v black box that is connected so the cnc. If I press the green button on this black box my spindle start turning for 2 seconds and then nothing. If I run the roadrunner g-code everything looks fine on my screen but my cnc is not doing anything.
This machine has been run before but not by me. I just want to at least be able to move the axis manually...

9
Now it seems to be kinda okey. The motor outputs are enabled again but I get a red light on Enable 1 and 2. And the machine is still completely dead.

10
Okey :) port and pins then disable all axis on motor output?

Pages: 1 2 »