1
Building or Buying a Wood routing table.. Beginnners guide.. / Re: Help with ports on mach3
« on: February 09, 2015, 07:25:14 PM »
Thank you I understand the amount of variables, at the time of posting this I wasn't with the machine.
The computer is a dual core Intel with 3gb of ram currently running Windows 7 64 bit
It didn't have a parallel port or serial, so I have installed a PCI card to allow for that.
The steper motors are being controlled via an
Isel microstep controller c142-4.1.
Output serial port.
The router head is being controlled via a
Kavo 4444
Output parallel port
The computer is a dual core Intel with 3gb of ram currently running Windows 7 64 bit
It didn't have a parallel port or serial, so I have installed a PCI card to allow for that.
The steper motors are being controlled via an
Isel microstep controller c142-4.1.
Output serial port.
The router head is being controlled via a
Kavo 4444
Output parallel port