Hello Guest it is March 28, 2024, 10:24:05 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Bill DeLong

Pages: 1
1
Mach3 under Vista / Which OS will run Mach 3 with the least hassle?
« on: February 03, 2015, 05:39:08 PM »
I recently ordered a CNC Router off eBay and expect it to arrive in about a week from now. In the mean time, I'd like to prep my PC and get a little familiar with the software while I'm waiting for the machine to arrive.

I currently have Win 7 32bit installed, but I use the PC for general home computing. I'm prepared to do a dual boot if necessary, but would like to know which OS will give me the least trouble?

I plan to lay the 3020 Router on a shelf above my PC in my hobby room.

2
Greetings everyone, total CNC noob here... I just ordered a hobby grade 3020 CNC Router off eBay and plan to get my feet wet within the next couple of weeks. I haven't purchased any software yet, but have been seriously considering Mach3 for my setup. I plan to place the machine on a shelf above my PC in my hobby room. I am an avid R/C Car Enthusiast who regularly races at the club level with various race tracks in my region. The only reason I purchased the CNC Router is to mill my own custom R/C Car parts to enhance performance and durability beyond what the industry is currently limited in offering.

Thanks!
Bill

Pages: 1