Hello Guest it is March 29, 2024, 10:52:45 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jon8949

Pages: 1
1
CS-Lab / CNC Router Retrofit to CSMIO/IP-S
« on: June 14, 2016, 04:47:17 PM »
I'm in the process of retrofitting a 1212 CNC Router motion control to CSMIO/IP-S.  The machine is currently up an running with the import BOB.  I just need to verify connection to the VFD. I'm currently able to control spindle on/off and spindle rpm.

Here is the current BOB connections.
BOB         VFD
0-10v        AI
GND         CM
COM         CM
P2            FWD

Here is what I believe it needs to be on with CSMIO/IP-S.  Please help me if this is not correct.

IP-S                             VFD
Analog 0-10v (Pin 1)       AI
GND (Pin 2)                   CM
Digital Out 0V(Pin14)      CM
Digital Out 0 (pin 0)        FWD

Thanks, Jon

2
General Mach Discussion / Re: 3D Cut Issue
« on: January 14, 2015, 09:42:49 PM »
Thank you both for the info.  I'll check that out tomorrow on the machine.

3
General Mach Discussion / 3D Cut Issue
« on: January 14, 2015, 08:38:26 PM »
Hi, hopefully someone might have a suggestion with my issue.  I have cut many flat parts without issue but recently just cut 2 3D patterns in tooling board.  Both had the same issue. The issue I'm having is from the top edge of the part to the side, it should be a sharp edge but it ended up with about a 1/16" radius on the edge.  The radius is consistent around the whole part.  All other dimensions are good on the finished part. Here is a like to a picture of the part.  http://i1148.photobucket.com/albums/o567/jon8949/CNC/IMG_20150114_184916668_HDR_zpsf47a663b.jpg

The 3D Rhino data file has the part with a sharp edge and I run Visual Mill for my CAM software.  During my simulation in Visual Mill it also shows a sharp edge.  I'm not sure if there is a setting in Mach3 that could be causing my issue.  I'm running a Gecko G540.

Any help would be appreciated.  Thanks, Jon

Pages: 1