Messages

1

Newfangled Mill Wizard / Re: Gcode on Circle, Arc and feed rate errors

« on: January 04, 2015, 07:04:09 PM »

Hi Ron,

Tks for the feedback;  tried again and worked but need to uncheck the "Spiral Z step"  if checked feed-rate keeps low;  understood very soon will have a new release and hope all this is fixed.; correct ?

Thank you

2

Newfangled Mill Wizard / Re: Gcode on Circle, Arc and feed rate errors

« on: January 04, 2015, 05:40:40 PM »

Hi Ron,

Above not completed;  creating a code with the wizards (the old version) the feed rate is OK.; I am using version Mill Wizard ver 1.00;  what is the latest one ?

Thank you

3

Newfangled Mill Wizard / Re: Gcode on Circle, Arc and feed rate errors

« on: January 04, 2015, 05:38:06 PM »

Hi Ron,

I am using Mill Wizard and always have low feed rate in circles;   this is the problem discussed here ?  and above file fixes it ?  if