Hello Guest it is August 08, 2020, 03:04:37 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Axle

Pages: 1
1
Works in progress / Re: Lathe / Mill Screens Under Development
« on: November 24, 2015, 10:42:58 PM »
can anyone tell me when the Mach 4 Lathe program will be out and ready to use.    Thanks      Axle

2
General Mach Discussion / Re: lathe threading
« on: April 01, 2015, 10:58:03 PM »
 Thanks Ron Rich and Hood for the response I think I may have explained the threading problem wrong all works wonderful in NSF turn and all works well in threading for 3 to 4 passes then all of a sudden it stops thinks a minute and moves to a new location then starts cutting a new thread in the air it does match up with DRO where ever it stops I did notice today that the RPM fluctuates when it decides to do this I have checked pulse signal and it is working on the board and in mach diagnostics what can make it change its mind in the middle of a thread I read in forum someone edited the G76 macro changed the test False to True can someone explain how and where to do this I am up for any thing.I read Hood you were going to switch to USB is this because of the signal speed and do you think I should..       Thanks Everyone       Axle.

3
Newfangled Solutions Mach3 Wizards / Re: NFS Turn Wizard
« on: March 31, 2015, 10:58:10 PM »
Hi everyone another NewBee trying to set up lathe all works fine except in threads using NSF thread wizard it appears the program gets confused and restarts in another place it will cut any where from 3 to 10 passes looking fine and then Dros values change, x will go positive .500/1.0 and z goes where ever it wants and then starts another thread cycle cutting air, first started with lap top and win. 7 used updated mach version then desk top pc xp and version .037 then installed updated version today with same results  please any help would be greatly appreciated.   Thanks   Axle.

Pages: 1