Hello Guest it is April 25, 2024, 05:42:35 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - scavenger

Pages: 1
1
Mach SDK plugin questions and answers. / Re: XBox360 Controller Plugin New User Info
« on: December 22, 2014, 08:03:37 PM »
I have two CNC machines running on MACH3. One is a Milling machine the other is a CNC Router. I have MACH3 profiles setup for each machine and both have worked fine. I have installed the XBOX360 Controller plugin and it works fine on the Mill but I cannot get the Router to operate with the controller. I have enabled the plugin but when I set the buttons and exit the config it does not operate. Will this only work for one profile or am I doing something wrong?

2
Forum suggestions and report forum problems. / Re: Forum help
« on: December 22, 2014, 08:00:48 PM »
I have two CNC machines running on MACH3. One is a Milling machine the other is a CNC Router. I have MACH3 profiles setup for each machine and both have worked fine. I have installed the XBOX360 Controller plugin and it works fine on the Mill but I cannot get the Router to operate with the controller. I have enabled the plugin but when I set the buttons and exit the config it does not operate. Will this only work for one profile or am I doing something wrong?

Pages: 1