Hello Guest it is March 28, 2024, 07:15:12 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Michael297

Pages: 1
1
General Mach Discussion / Zero Radius Arc
« on: December 14, 2014, 03:37:35 PM »
I would appreciate some input on a "Zero Radius Arc" message I'm getting.  I've searched to the ends of the Internet and had no luck.  The error is cutting dogbone fillets out of a part.  I'm using a 1/8 endmill and the fillet's at .125"  As suggested by other posts I drew a .125" diameter circle at the problem area representing the tool and it fit in and out of the fillet correctly.  The code as G91.1 a the beginning as other posts have indicated. 

I seem to get the error anywhere where I see I0.0000J0.0001 as part of the line.  The first error I get on the following Gcode is line 3540. 
G-Code link - https://www.dropbox.com/s/nr18osxm5hqwfji/f15new.txt?dl=0
Thanks for any help,
Mike


Pages: 1